24/7 EMERGENCY RESPONSE EMERGENCY ONSITE IN 45 MINUTES DIRECT INSURANCE BILLING IICRC CERTIFIED FIRM
Real People. 24/7.A live person answers
45-Minute ResponseFor emergency calls
Direct Insurance BillingHelp with claim documentation
IICRC Certified FirmProfessional restoration standards

Before the First Freeze: How to Winterize Outdoor Faucets and Pipes in Vancouver, WA

Every fall, your garden hose quietly assumes it gets to stay out all winter. It does not. In Vancouver, Clark County and the Portland metro, a hose left on the spigot is one of the easiest ways to turn the first cold night into a burst pipe, a soaked wall and a very bad Saturday. The good news: winterizing your outdoor faucets and exposed pipes takes about an hour, and you probably already own most of what you need.

Why the first freeze catches Pacific Northwest homes off guard

Our winters are usually mild, which is exactly the problem. Many local homes have pipes in crawlspaces, garages and exterior walls that were never insulated, because most nights stay above freezing. Then a cold east wind blows out of the Columbia River Gorge, temperatures drop into the 20s for a night or two, and water sitting in an unprotected pipe freezes.

Water expands when it freezes. That pressure has to go somewhere, and it often splits the pipe at its weakest point. The tricky part is that the leak doesn’t show up until the ice thaws, so a pipe can crack overnight and start leaking inside a wall or under the floor hours later.

Step 1: Unhook and drain every hose

This is the big one. A connected hose holds water in the faucet, and even a “frost-free” faucet (the kind with a long stem that shuts off inside the wall) can’t drain when a hose is attached. Ice backs up into the pipe inside your wall, where you can’t see it.

  • Disconnect every hose, including the one behind the shrubs you forgot about.
  • Drain hoses and store them in the garage or shed.
  • Take off any splitters, timers or quick-connect fittings too.

Step 2: Shut off and drain outside faucets

Many homes have an indoor shutoff valve for each outside faucet, usually in the crawlspace, basement, garage or a utility area near the faucet.

  1. Close the indoor shutoff valve.
  2. Open the outside faucet and let it drain completely.
  3. Leave the outside faucet open for the winter so any leftover water has room to expand.

No indoor valve? That’s common. A foam faucet cover (a few dollars at any hardware store) still adds real protection.

Step 3: Insulate exposed pipes

Walk your crawlspace (or have someone do it) and look at your garage and any unheated spaces.

  • Wrap exposed pipes with foam pipe insulation, paying extra attention to pipes near vents, rim joists and exterior walls.
  • Make sure crawlspace insulation hasn’t fallen down and left pipes bare.
  • If you have an irrigation system, have it blown out before the cold sets in.

While you’re down there, look for anything that’s already wet. A small drip in October can become a big repair by January.

Step 4: Know your main shutoff before you need it

If a pipe does burst, the first few minutes matter most. Find your main water shutoff now (often in the crawlspace, basement, garage or at the street) and make sure it turns. Show everyone in the house where it is. A tagged valve and a flashlight nearby are cheap insurance.

Step 5: Plan for deep cold snaps

When the forecast calls for a hard freeze:

  • Let faucets on exterior walls drip slowly overnight.
  • Open sink cabinet doors on outside walls so warm air reaches the pipes.
  • Keep the thermostat at 55°F or higher, even if you’re traveling.

What to do if a pipe bursts anyway

Shut off the main water, turn off power to any wet areas if it’s safe to do so, and move valuables out of the way. Take photos for your insurance company before anything gets moved or thrown out. Then call a water damage restoration company quickly, because water keeps traveling into drywall, insulation and subfloors long after the leak stops.

ARS Restoration Services has been serving Vancouver and the Portland metro since 2000. We’re IICRC certified, available 24/7, and onsite in 45 minutes for emergencies. We also help you work with your insurance company. Learn more about our water damage restoration services or contact us. WA (360) 907-0156, OR (503) 487-1501.

FAQ

Do I really need to disconnect my hose if I have a frost-free faucet?

Yes. A frost-free faucet only works if water can drain out of it. With a hose attached, water stays trapped and can freeze inside the wall, where a crack is hard to spot until it leaks.

Should I leave my outside faucet open or closed for winter?

If you’ve shut the indoor valve, leave the outside faucet open so any remaining water can drain and has room to expand.

How do I know if a pipe froze and cracked?

Watch for little or no water from a faucet during a cold snap, new damp spots, a musty smell, or a jump in your water bill. If you suspect a leak inside a wall or under the floor, shut off the water and call a pro before the thaw makes it worse. If a pipe does burst, close the main valve and call for emergency water removal in Vancouver.

Get Started Today

Have Additional Questions?

Our team is standing by 24/7 and ready to help. Whether you need emergency assistance or just have a question.

Call Us

(360) 907-0156

(360) 907-0156
Chat with us